Continuous Output (#( 4)); Delete (#( 5)) - Mitsubishi Electric MELDAS C6 Instruction Manual

2.6.6.5 Continuous Output (#( 4))

• Machining programs in the NC memory are continuously output as flash ATA card files.
Single file designation and batch designation output are also possible.
• If reset is executed during the output, the output data up to that point will be valid.
(1) Example of continuous output setting
Example 1
(2) Precautions
(Note 1) If the range is not designated, the files will be output with single file designation.
(Note 2) An error will occur if edit lock is ON.
(Note 3) If a machining program having the same No. as a file name in the flash ATA card is

2.6.6.6 Delete (#( 5))

• Files in the designated directory in the flash ATA card or the directory are deleted. Add "/" to the end
to designate a directory.
Batch designated delete is also possible.
• A message confirming the deletion process will appear.
(1) Example of delete setting
Example 1
Example 2
Example 3
Example 4
Example 5
Example 6
(Note)
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Example of conditions
Output data in the range of machining program
No. "100" to "200" as file name "100" to "200".
found in the designated range, a message confirming whether to overwrite will appear.
Example of conditions
Delete file name "100" from the current
directory.
Batch delete files without extension from the
current directory.
Batch delete all files in the current directory
regardless of whether an extension is
assigned.
Batch delete files with the extension ".DAT"
from the current directory.
Batch delete all files having a 4-digit name
starting with A1 from the current directory.
Delete the directory "DATA" and all data
contained from the flash ATA card.
Refer to "2.6.6.9 All Delete" to delete all data in the flash ATA card.
search engine
2.6 Data In/Out
# ( 4) (
# ( 5) (
# ( 5) (
# ( 5) (
# ( 5) (
# ( 5) (
# ( 5) (
I - 176
Setting
100) ( 200)
Setting
100) ( )
∗ ) (
)
∗ . ∗ ) (
)
∗ .DAT) (
)
A1++) ( )
DATA/) ( )