Cycle Start And Feed Hold; Feed Axis Selection - Mitsubishi Electric MELDAS C6 Instruction Manual

5.7 Cycle Start and Feed Hold

Use the CYCLE START switch to start automatic
operation (memory, tape, or MDI). Automatic
operation is executed by turning on the switch. Use
also the switch for restart from stop by the FEED
HOLD switch or the automatic operation stop state.
The CYCLE START switch becomes effective when the switch is turned on, then off.
Use the FEED HOLD switch to temporarily stop automatic operation (for example, deceleration stop
of the control axis during automatic operation). To restart operation, use the CYCLE START switch.

5.8 Feed Axis Selection

Use the FEED AXIS SELECT switch to start the
controlled axis during manual operation. While the
FEED AXIS SELECT switch is held on, the selected
controlled axis is moved. When the switch is turned
off, the controlled axis move stops.
Downloaded from ManualsNet.com
5. Operation Panel Switches in Operation Mode
5.7 Cycle Start and Feed Hold
search engine
CYCLE START
+X
-X
II - 18
FEED HOLD
FEED AXIS SELECT
+4
+Y +Z
-Y -Z
-4