Mitsubishi Electric MELDAS C6 Instruction Manual page 288

3.4.6.1 Examples of Operation]
(1) Copying multiple machining programs in a batch (NC unit to memory card)
When "ALL" is designated for the copy source, all machining programs can be copied to one file.
<Precautions>
Downloaded from ManualsNet.com
3. Screen Operation When Using a Panel Computer
3.4 Data In/Out Screen (For only the panel computer)
NC unit
O1000(TEST)
N1G28X0.Y0.Z0.
:
N999M02
%
O1001(TAP )
G84W-100.R0.P2000
:
M30
%
O9999( )
G92X0.Y0.Z0.
:
M30
%
• A message confirming the operation will first appear before the files are copied. Copying will
start only when execution is instructed in respect to the confirmation message.
• When the files that already exist in the copy destination are to be overwritten, a confirmation
message will first appear. The files will be overwritten when YES is selected.
• When the files to be overwritten are in a storage device such as a memory card, the data
cannot be copied if the file attributes are read-only.
• While the machining programs are copied, if there is a file that cannot be copied because of
the data protection function, the O No. and a confirmation message will appear. The file will
be created with the data that was copied successfully before the protected file. If the first file
could not be copied, a file containing only "%" will be created.
search engine
Memory card file
O1000(TEST)
N1G28X0.Y0.Z0.
:
N999M02
O1001(TAP
Batch copy
G84W-100.R0.P2000
function
:
⇒
M30
O9999( )
G92X0.Y0.Z0.
:
M30
%
I - 273
)