Outputting Tool Offset Data - Mitsubishi Electric MELDAS C6 Instruction Manual

2.6.2.2 Outputting Tool Offset Data

Tool offset data which is set and displayed on the screen can be output. The output operation can
be made also during automatic operation.
The output tape length varies with the tool offset type, the number of sets, and the offset data
numeric. For the 40-set specification, this length is 3 to 4m for type I and 12 to 16m for type II.
(1) Tool offset data is output as follows:
Set the data type to tool data.
# ( 2 ) DATA (
Press the
1) Data output is started.
2) After the end code % (EOR) is output,
(2) Output format
The data area format is the same as tool offset input (G10) and work offset input (G10) by the
program.
The data is output in the order of the tool offset and workpiece coordinate offset data.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
)
key.
INPUT
The contents of output data and message
"DATA OUT EXECUTION" are displayed.
data output ends with message "DATA
OUT COMPLETE" displayed.
search engine
2.6 Data In/Out
I - 145