Data Input And Compare - Mitsubishi Electric MELDAS C6 Instruction Manual

Output of independent data
Set 9 9 in the # setting area,
and the No. of the data to be
output in the data setting area.
(Ex. Common variable)
# (99) DATA (
Press
1) The output will start, and the
2) The output operation will end

9.2.3 Data Input and Compare

(1) Explanation of function
(Note 1) If data that exceeds the actual memory size is input or compared, the data of the memory
(Note 2) The data protection key setting will basically be ignored.
(Note 3) To stop the APLC, enter the emergency stop state, and then set rotary switch NCSYS to
Downloaded from ManualsNet.com
9.2 Data Input/Output by RS-232C
209)
.
INPUT
output data No., output data
details, and "DATA
EXECUTION" message
display.
when the end code % (EOR) is
output, and the message "DATA
OUT COMPLETE" displays.
(Note 1) The setting of the data protection key will be ignored.
(Note 2) Data not found in the specifications will not be output.
When the APLC is stopped, the data output from the input screen can be input and compared.
The target data is the same as for data output.
This function is valid only when the user PLC is stopped.
size will be read in and then the message "E10 MEMORY OVER" will display. The
operation will stop.
"1".
search engine
9. Maintenance Functions
OUT
will
III - 60