Mitsubishi Electric MELDAS C6 Instruction Manual page 218

# Parameter
0 INIT. SET
1 ORIGIN
2 ZERO
This section explains only the ABS POSITION SET screen. For details of the actual absolute position
initialization and display contents, see Chapter 3, Section 4 "Absolute Position Detection System".
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Select the axis for which absolute position initialization is to
be performed:
0: Do not perform initialization.
1: Perform initialization.
(Note) "0" is set when the power is turned on again.
This parameter is valid when the origin point alignment
method is used. Specify 1 when the machine has been
positioned to the origin point.
(Note) This parameter is invalid for other methods.
This parameter is used to determine the basic machine
coordinate system.
Specify the coordinates of the machine basic position seen
from the zero point of basic machine coordinate system or
absolute position basic point.
(Whether the machine basic position or absolute position
basic point is used is determined by data specified for #2059
"zerbas" of the setup parameter.)
search engine
2.7 Diagnosis
Explanation
ZERO
I - 203
Setting range (unit)
0/1
0/1
± 99999.999 (mm)