Execution Modal Monitor - Mitsubishi Electric MELDAS C6 Instruction Manual

2.2.3.2 Execution Modal Monitor

By switching the screen from the execution program's monitor screen (in the previous section) by
using the
displays the modal values of the active machining program for monitoring.
O12345678 N12345-12
<SUB>
[WORK]
X
Y
Z
C
[MODAL INFORM.]
G01..........G94
G66.1.......G50.1
G41:D =
G43:H =
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
key, the execution modal's monitor screen is displayed. This screen mainly
NEXT
Display item
The currently executing program number, sequence number, and
block number are displayed.
O1000 When a subprogram is being executed, the program number,
N200-30 sequence number, and block number of the subprogram are
displayed.
The coordinates in the workpiece coordinate system being
100.000 currently executed are displayed. (Same as POSITION screen)
200.000
300.000
0.000
The modal state of the current G command being executed is
displayed.
(Note) Fixed cycle operation:
The tool radius compensation modal and offset number and wear
amount are displayed.
The tool length offset and offset number and wear amount are
displayed.
search engine
2.2 Monitor
[MODAL INFORM.]
O12345678
<SUB> O 1000 N 200-30
G01 G17 G91
G21 G80 G98
G67 G97 G50.1
G69 :R= G05 :P 3
G40.1 G54.1:P48
G40: D =
G49: H =
: H =
FA 24000.00 S1 1000 M 12345678
FM 1200.00 S2 2000
FS 0.0000 T 1234
B 1234
N300 G1 X-100.000 Y12345.678 F2000 ;
POSI COOR COMMAND
Explanation
When a fixed cycle command is executed, the G command
in the fixed cycle control subprogram does not reflect the
G modal of the calling source program.
I - 34
MONITOR 3.2/3
[WORK]
X 0.000
G94 Y 0.000
G64 Z 0.000
G43.1 C 0.000
10
35
40
SEARCH MENU