Mitsubishi Electric MELDAS C6 Instruction Manual page 289

(2) Copying several machining programs in a file (Memory card to NC unit)
A file containing several machining programs in one file, such as a file created with batch backup,
can be copied to the NC unit with the COPY function.
When a file created with batch backup is copied, the operation will differ as shown below according
to the selection state of the copy destination file.
destination file
O No. selected
Not selected
<Precautions>
Downloaded from ManualsNet.com
3. Screen Operation When Using a Panel Computer
3.4 Data In/Out Screen (For only the panel computer)
Memory card file
O1000(TEST)
N1G28X0.Y0.Z0.
:
N999M02
O1001(TAP )
G84W-100.R0.P2000
:
M30
:
:
O9999( )
G92X0.Y0.Z0.
:
M30
%
Copy Machining program
Head machining program
Second and following
machining programs
All machining programs
• If machining programs already exist, a confirmation message will appear before overwriting.
The files will be overwritten only when the overwrite execution is instructed. If overwrite is not
instructed, copying will continue from the next O No. in the file.
• The "%" line at the head of the file is ignored. ("%" is inserted for an RS-232C output file, etc.)
• If the O No. does not appear even once in the file, a message indicating that copying failed
will appear.
• While the machining programs are copied, if there is a file that cannot be copied because of
the data protection function, the O No. and a message will appear. If YES is selected,
copying will continue from the next O No. in the file.
search engine
NC unit
O1000(TEST)
N1G28X0.Y0.Z0.
N999M02
%
O1001(TAP
G84W-100.R0.P2000
COPY function
⇒
M30
%
O9999( )
G92X0.Y0.Z0.
M30
%
in file
The head O No. in the file is ignored, and the
selected machining program is overwritten.
The machining programs are copied according
to the O numbers in the file.
The machining programs are copied according
to the O numbers in the file.
I - 274
:
)
:
:
Operation