Canon imagePRESS 1135 Series Service Manual page 1196

COPIER > OPTION > IMG-FIX
NCR-SW Set fix improvement mode: carbonless ppr
Lv.2 Details To set whether to improve the fixing performance for carbonless
paper.
When 1 is set, fixing performance for carbonless paper is improved,
but productivity decreases.
Use case When fixing failure occurs on carbonless paper
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: OFF, 1: ON (Fixing improvement mode)
Default value 0
8
Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > IMG-TR
T-8-62
8 Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > IMG-TR
■ IMG-TR
COPIER > OPTION > IMG-TR
1ROT-TIM Set idling time in pri trans conduction
Lv.2 Details Setting the time for idle rotation while the primary transfer is at
conductive state.
1 increment of the value increases the time for idle rotation by 10
sec.
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Display/adj/set range 0 to 300
Unit 10 sec.
2ROT-TIM Set idling tie in sec trans conduction
Lv.2 Details Setting the time for idle rotation while the secondary transfer is at
conductive state.
1 increment of the value increases the time for idle rotation by 10
sec.
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Display/adj/set range 0 to 300
Unit 10 sec.
1ROT-CC Current adj at primry trns cndctv idling
Lv.2 Details When resistance value of the primary transfer roller is too low,
there will be white dots on image. Although this resistance value is
increased by executing idle rotation while applying bias voltage to
the primary transfer roller, increasing the current can increase the
resistance value in a short time.
1 increment of the value increases the current by 5.0 micro A.
Use case Increase the value in the case of white spot (dot) on HT image.
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range -10 to 10
Unit 5.0 micro A
Default value 0
Related service mode COPIER> FUNCTION> MISC-P> 1-ROT-EX
8-253
8-253