Canon imagePRESS 1135 Series Service Manual page 1191

COPIER > OPTION > IMG-FIX
TEMP-09 Adj of fixing temp (POD3 middle deck)
Lv.2 Details Adjusting fixing temperature.
- Plain paper 1 (up to 79 g/m2)/ plain paper 2 (80 to 105 g/m2)
To reduce fixing temperature, reduce the fixing temperature and
the temperature of external heat 1/external heat 2 following the
ratio of 1:2 (if the fixing temperature is -1 deg C, set external
heat 1/external heat 2 temperature to -2 deg C). To increase
temperature, increase only the fixing temperature while keeping
external heat 1/external heat 2 temperature to 230 deg C.
- Any paper other than plain paper 1 (up to 79 g/m2)/ plain paper 2
(80 to 105 g/m2)
Increase/reduce only the fixing temperature while keeping external
heat 1/ external heat 2 temperature to 230 deg C.
Perform this setting separately with each deck.
Use case In the case of trouble
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range -10 to 3
Unit 1 deg C
Default value 0
Supplement/memo Increase the range to reduce the temperature because the
fixing roller can be soiled with ink melt with preprint paper (plain
paper reduces the external heat temperature because the
fixing temperature will not be reduced if just adjusting the fixing
temperature).
8
Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > IMG-FIX
8 Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > IMG-FIX
COPIER > OPTION > IMG-FIX
TEMP-10 Adj of fixing temp (POD3 lower deck)
Lv.2 Details Adjusting fixing temperature.
- Plain paper 1 (up to 79 g/m2)/ plain paper 2 (80 to 105 g/m2)
To reduce fixing temperature, reduce the fixing temperature and
the temperature of external heat 1/external heat 2 following the
ratio of 1:2 (if the fixing temperature is -1 deg C, set external
heat 1/external heat 2 temperature to -2 deg C). To increase
temperature, increase only the fixing temperature while keeping
external heat 1/external heat 2 temperature to 230 deg C.
- Any paper other than plain paper 1 (up to 79 g/m2)/ plain paper 2
(80 to 105 g/m2)
Increase/reduce only the fixing temperature while keeping external
heat 1/ external heat 2 temperature to 230 deg C.
Perform this setting separately with each deck.
Use case In the case of trouble
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range -10 to 3
Unit 1 deg C
Default value 0
Supplement/memo Increase the range to reduce the temperature because the
fixing roller can be soiled with ink melt with preprint paper (plain
paper reduces the external heat temperature because the
fixing temperature will not be reduced if just adjusting the fixing
temperature).
FX-LVL01 Set of fixing abilty (host machine deck)
Lv.1 Details Setting for fixing performance.
Selecting the mode with priority on fixing performance makes the
paper in the deck to be fed with the sequence to improve fixing
performance (increasing fixing temperature + drop in throughput).
Perform this mode separately for each deck.
Use case In the case of low fixing performance
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: Standard mode, 1: Mode with priority on fixing performance
Default value 0
Supplement/memo Following can be applied at the same time: COPIER> OPTION>
IMG-FIX> OHP-TEMP
8-248
8-248