Canon imagePRESS 1135 Series Service Manual page 1245

COPIER > OPTION > USER
DFLT-ADJ Initial dspl of auto gradatn corrct trgt
Lv.1 Details Set the initial display (highlighted in blue) for the target items for
full correction/quick correction in the automatic gradation correction
screen in the user mode.
The setting can be made only when the EFI controller is connected
or for the copy model in which Adobe PS/PDF is available.
When 0 is set, the target items for correction are not displayed.
When 1, 2, or 3 is set, the target items for correction (copy/printer/
both) are displayed, and any of them can be selected (highlighted in
blue).
Use case To switch the initial display for automatic gradation correction
Display/adj/set range 0 to 3
0: Do not display the target items for correction.
1: "Copy" is selected for the target item for correction.
2: "Printer" is selected for the target item for correction.
3: "Both" is selected for the target item for correction.
Default value 0
Related user mode Initial setting/registration> Adjustment/cleaning> Automatic gradation
correction
PBMAX-N3 Set max signature at P-binder: thin PP2
Lv.1 Details Setting the maximum number of sheets for inner sheet/signature (thin
paper 2) with perfect binder.
Use case In the case to increase the maximum number of sheets for original
with perfect binder.
Adj/set/operate method Enter the setting value, and then press OK key.
Caution In the case of specifying the number of sheets for inner sheet/
signature that is out of the product specification guarantee, check
in advance that the stack thickness with the maximum number of
sheets is 25 mm or less. Also inform the user that the operation is
not guaranteed before setting this mode.
Display/adj/set range 150 to 300
Appropriate target value 200
Default value 200
Related service mode COPIER> OPTION> USER> PBMAX-N1, PBMAX-N2, PBMAX-T1,
PBMAX-T2, PBMAX-T3, PBMAX-T4, PBMAX-T5, PBMAX-T6
8
Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > USER
8 Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > USER
COPIER > OPTION > USER
DK10ASST Air heater setting of POD3 lower deck
Lv.1 Details Setting the condition (media, environment) to turn ON the floatation
air heater in the lower deck of the 2nd (additional) secondary POD
deck.
When switching media from non-coated paper to coated paper,
pickup is not be started until the floatation air heater reaches the
specified temperature. To shorten wait time, specify the setting that
is not dependent on media.
If the use environment is close to the threshold for turning ON/OFF,
wait time gets longer because of frequent switch. To shorten wait
time, specify the mode always to be ON.
Use case Upon request to shorten the wait time.
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Caution • In the case to specify the mode that is not dependent on media, be
sure to inform the user about the possibility of drop in transferring
performance of non-coated paper and get an approval of the user
before executing this mode.
• In the case to always turn ON, be sure to inform the user about the
possibility of drop in transferring performance under low humidity
environment and get an approval of the user before executing this
mode.
Display/adj/set range 0 to 2
0: Dependent on media and environment condition
1: Dependent on environment condition (no dependence on media)
2: Always turning ON the air heater (no dependence on environment
and media)
Default value 0
Related service mode DK1-ASST to DK9-ASST
8-302
8-302