Canon imagePRESS 1135 Series Service Manual page 1140

■ FEED-ADJ
COPIER> ADJUST> FEED-ADJ
REG-SLID Set of offset level of side regist shift
Lv.1 Details To set the offset level of side registration shift amount for the
measure against the fixing assembly paper edge.
Enter the value for front into 1st line and for back into 2nd line
respectively.
As the value is increased by 1, the level goes up 2 notch (shift
amount is increased by 1 mm).
Use case • When the image adjustment is not appropriate.
• When the alignment is not appropriate at delivery.
• When the paper edge cuts of fixing assembly appears on the
image.
Adj/set/operate method When the image adjustment or alignment at delivery is not
appropriate: lower the level to decrease the shift amount.
When the paper edge cuts of fixing assembly appears on the image:
raise the level to increase the shift amount.
Caution • As the smaller value is set, it effects the paper cuts of fixing
assembly and the life of fixing assembly is shortened.
• As the greater value is set, it may lead to the failure of image
adjustment or alignment at delivery.
Display/adjust/set range 0 to 6
0: level 1 (0.5 mm), 1: level 3 (1.5 mm), 2: level 5 (2.5 mm),
3: level 7 (3.5 mm), 4: level 9 (4.5 mm), 5: level 11 (5.5 mm),
6: level 13 (6.5 mm)
Unit 2 levels
Default value 3
8
Service Mode > COPIER > ADJUST (Adjustment Mode) > FEED-ADJ
8 Service Mode > COPIER > ADJUST (Adjustment Mode) > FEED-ADJ
COPIER> ADJUST> FEED-ADJ
REG-TOP Adj of lead edge regist position
Lv.1 Details Based on the value read by a test print, adjust the laser writing start
position in sub scanning direction that is set at the factory.
Set the value in which the lead edge margin is within the standard (2.5
-/+ 0.5 mm).
Enter the value for front into 1st line and for back into 2nd line
respectively.
As the value is changed by 1, the image is shifted by 0.1 mm toward
the feed direction.
+: trailing edge direction (lead edge margin is increased)
-: lead edge direction (lead edge margin is decreased)
Use case • At the initial installation check.
• At the check/adjustment when the write reference sensor is
replaced.
• At the check/adjustment when the reflection/transparent sensor in
active registration is replaced.
• At the check/adjustment when the active registration unit is
replaced.
Adj/set/operate method 1) Output a test print.
2) Measure the leading edge margin.
3) Enter the adjustment amount for leading edge margin.
4) Output a test print and check it.
Caution This setting is applied to all the media settings that users are set.
Execute the adjustment on media basis in additional function mode.
Display/adjust/set range -50 to 50
Unit 0.1 mm
Default value 0
8-197
8-197