Canon imagePRESS 1135 Series Service Manual page 1153

COPIER> ADJUST> MISC
IETBL-BB Set of black band eject environmnt table
Lv.2 Details To set whether to enable or disable the environment table that
defines the toner ejection amount in black band mode.
If this is set to "1 (disable)", environment table is not used and
threshold value of toner ejection is set to 5 %.
Use case • When continuously feeding the low-duty jobs for a long term in
low density environment.
• When feeding the chart with different density in longitudinal
direction.
• When users do not want to change the interruption timing.
Adj/set/operate method Enter the setting value and press OK key.
Display/adjust/set range 0 to 1
0: Enable, 1: Disable
Appropriate target value 0
Default value 0
Related service mode COPIER> ADJUST> MISC> TRSD-BB, MAXT-BB
MAXT-PBB Set B band length after D-maxD-half cont
Lv.2 Details To set the black band length by adjusting the black band toner
ejection time that is executed after the patch image reading
detection.
As the value is increased by 1, the black band is extended by
10 mm.
Use case • When the problem occurs during the clearing.
• When trying to save the toner consumption.
Adj/set/operate method 1) Enter the setting value and press OK key.
2) Execute D-max control and D-half control manually.
3) Check the sleeve ghost in half-tone.
Display/adjust/set range 0 to 42
Unit 10 mm
Appropriate target value 21 to 42
Default value 0
PG-BB Black band pattern setting
Lv.1 Details To set the pattern at black band mode.
If the black band ejection time is reduced (improve the productivity),
set to 2.
If the density is thin, set to 0/1.
Use case • When continuously feeding the low-duty jobs for a long term.
• To improve the productivity
Adj/set/operate method Enter the setting value and press OK key.
Display/adjust/set range 0 to 2
0 : black band image pattern 0, 1 : black band image pattern 1, 2 :
black band image pattern 2
Default value 0
8
Service Mode > COPIER > ADJUST (Adjustment Mode) > MISC
8 Service Mode > COPIER > ADJUST (Adjustment Mode) > MISC
COPIER> ADJUST> MISC
CLBACSW Dst coll bias ONOFF drg blk/wht band md
Lv.2 Details Set ON/OFF of the dust collecting bias during black band/white band
ejection
When the toner from the dust collecting bias roller get harden and
drop, and that dropped toner soiled the primary pre-transfer charging
assembly, set it to 1/2.
If toner of other area is soiled, set it to 0/3.
Use case • When the toner from the dust collecting bias roller get harden and
drop.
• If the primary pre-transfer charging assembly is soiled by the
toner.
Adj/set/operate method Enter the setting value, and press OK.
Display/adjust/set range 0 to 3
0 : if black band ON, if white band OFF, 1: if black band OFF, if white
band ON, 2 : if black band/white band in the same time OFF, 3 : if
black band/white band in the same time ON
Default value 0
8-210
T-8-44
8-210