Canon imagePRESS 1135 Series Service Manual page 1460

5) Toner supply is started for sending toner to the developing assembly (Normally, it takes approx 15 to 20 minutes; however, it takes maximum 25
minutes depending on the installation environment and storage period of toner container.).
Get in Service Mode to select the following: COPIER > FUNCTION > INSTALL > TONER-S
Display I/O Adjust Function Option
<INSTALL > < 1/ 1 > <NO-PAPER>
TONER-S Check the Developer
CARD 3 ( 3) { 1
E-RDS 0 ( 0) { 0
RGW-PORT 443 ( 443) { 1
COM-TEST
COM-LOG
RGW-ADR https://a01.ugwdevice.net/ugw/agenti
INIT-ITB
6) When <NO TONER> is displayed at the upper right on the Service Mode screen, put the second toner container.
NOTE :
• You can set the 2nd toner container when <NO TONER> is displayed while TONER-S is in progress (toner is being stirred).
• Auto stirring only for the 2nd bottle
• Although the machine can operate with only 1 toner container installed, a message is shown telling: "Toner container can be replaced"
on the control panel.
• During TONER-S processing, put the labels, release the control panel support shaft and set the paper.
• When not to install the color image reader simultaneously, fix the top board during TONER-S processing.
• When installing the color image reader simultaneously, install the reader after this equipment is installed.
9
Installation > Installation > Setting the toner container
Test Counter Display I/O
<INSTALL >
TONER-S 194 sec
2001} CARD
1} E-RDS
65535} RGW-PORT 443
COM-TEST
COM-LOG
RGW-ADR https://a01.ugwdevice.net/ugw/agenti
INIT-ITB
OK
F-9-92
9 Installation > Installation > Setting the toner container
Adjust Function Option Test Counter
< 1/ 1 > <SERVICE >
3 ( 3) { 1 2001}
0 ( 0) { 0 1}
( 443) { 1 65535}
OK
F-9-93
9-43
9-43