Canon imagePRESS 1135 Series Service Manual page 1167

COPIER> FUNCTION> CLEAR
ERDS-DAT Initialization of E-RDS SRAM data
Lv.1 Details Initialize the SCM value of the Embedded-RDS stored in the SRAM.
SCM values are ON/OFF of E-RDS, server's port number, server's
SOAP URL, and communication schedule with the server (how often
the data is acquired), etc.
The value set by COPIER> FUNCTION> INSTALL> E-RDS, RGW-
PORT, RGW-ADR, COM-LOG is cleared.
Use case At the time of updating the Bootable version in the E-RDS
environment
Adj/set/operate method Select the item and press the OK key.
Caution The method of using the SRAM in E-RDS differs depending on the
Bootable version. Therefore, unless the SRAM data is cleared at the
time of version update, data inconsistency occurs.
Display/adjust/set range When operation finished normally: OK, When operation failed: NG
Related service mode COPIER> FUNCTION> INSTALL> E-RDS, RGW-PORT, RGW-ADR,
COM-LOG
KEY-CLR Encryptin key clear of HDD encrypt board
Lv.2 Details Clear the encryption key for the HDD encryption board (security kit)
for replacement.
Processing is executed at the time of replacement of the encryption
board, and a new encryption key is generated.
Use case At the time of replacement of the encryption key for the HDD
encryption board
Adj/set/operate method 1) Select the item and press the OK key.
2) Check that OK is displayed.
3) Turn OFF/ON the main power.
Caution Since all data in the HDD becomes unavailable when executing this
item, be sure to initialize the HDD after turning OFF/ON the main
power.
Display/adjust/set range When operation finished normally: OK, When operation failed: NG
INIT-DSP Initialize operation mode display seting
Lv.1 Details Initialize the setting of the item displayed in the operation
maintenance mode.
All the values set by PD1-SW, DB1-SW, CLN-SW return to initial
values for each destination.
Use case To set the parts display setting back to the default value
Adj/set/operate method Select the item and press the OK key.
Related service mode COPIER> COUTER> PD1-SW, DB1-SW, CLN-SW
8
Service Mode > COPIER > FUNCTION (Operation / Inspection Mode) > MISC-R
T-8-55
8 Service Mode > COPIER > FUNCTION (Operation / Inspection Mode) > MISC-R
■ MISC-R
COPIER> FUNCTION> MISC-R
SCANLAMP Light-up check of scanning lamp
Lv.1 Details Light up the scanning lamp for 3 seconds.
Use case At the time of replacement of the scanning lamp
Adj/set/operate method Select the item and press the OK key.
Display/adjust/set range During operation: ACTIVE, At termination: OK!
Required time 3 seconds
8-224
T-8-56
8-224