Canon imagePRESS 1135 Series Service Manual page 1392

SORTER> OPTION
TBPCOUNT Set blade rest shift threshold VL:P-Bind
Lv.1 Details To set the shift threshold value of the blade rest on the Perfect
Binder.
When the number of trimming of paper stack reaches the setting
value x 10 times, the blade rest moves.
As the smaller value is set, the shift timing of the blade rest becomes
earlier.
Decrease the value when a trimming failure occurs before reaching
the expected trimming times.
Use case When the trimming failure occurs
Adj/set/operate method 1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power.
Display/adj/set range 10 to 110
Unit 10 times
Default value 110
TBP-POSW Set of blade rest position: P-Bind
Lv.1 Details To set the blade rest position on the Perfect Binder.
The current blade rest position is displayed.
Increase the value by 1 from its current value to change the position.
Use case When the trimming failure occurs
Adj/set/operate method 1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power.
Display/adj/set range 0 to 9
Default value 0
TBP-MVSW Set of blade holder shift mode: Fin-AF
Lv.1 Details To set whether to separate the usage of finisher blade holder for top/
bottom and for fore-edge.
Use case When small cuts appears on the surface, replace the blade holder
and change the usage of blade holder at the same time
Adj/set/operate method 1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power.
Display/adj/set range 0 to 1
0: Not separate for top/bottom and fore-edge
1: Separate for top/bottom and fore-edge
Default value 0
8
Service Mode > SORTER > OPTION
8 Service Mode > SORTER > OPTION
SORTER> OPTION
CURL-SW Set of curl mode
Lv.1 Details To set the delivery speed according to the curl direction (upward/
downward curl).
To improve the stack failure due to paper curl.
Use case When stack failure occurs due to paper curl
Adj/set/operate method 1) Enter the setting value and press OK.
Display/adj/set range 0 to 2
0: Normal operation
1: Upward curl mode setting (accelerate the delivery speed at upper
delivery/lower delivery)
2: Downward curl mode setting (decelerate the delivery speed at
lower delivery)
Default value 0
Related service mode SORTER> OPTION> TRY-EJCT
Supplement/memo Same setting can be specified at the service-specific DIP switch on
the finisher. Same setting value is applied to the finisher side and the
host machine side.
TRY-OVER Set limit of stack capacity: Fin-AF/AG
Lv.1 Details To set the limit of stack capacity for extra-long paper or coated paper
that is stacked to tray A in high volume stack mode at the finisher
(Fin-AF).
To set the limit of stack capacity for Z-fold paper and half hold paper.
("Stack over" is detected when the paper is stacked over the limit of
stack height.) (Fin-AG)
If the limit of stack capacity is removed, paper can be stacked
beyond the maximum stack capacity.
Use case When stacking the paper beyond the maximum stack capacity of tray
Adj/set/operate method 1) Enter the setting value and press OK.
2) Turn OFF/ON the main power switch.
Caution Tell users and get an agreement that when the high density paper is
stacked until the maximum volume, a tray may not be able to move
up.
Display/adj/set range 0 to 1
0: Normal operation, 1: Remove the stack limit
Default value 0
8-449
8-449