Canon imagePRESS 1135 Series Service Manual page 1508

2) Pass the cable [1] of the heater unit through the cable guide [2] of the heater mount.
x1
3) Fit the heater unit [1] to the 2 bosses [2] on the heater mount to install.
• 1 Screw (Toothed Washer:M4X8) [3]
x1
[1]
9
Installation > Cassete Heater-32 > Installation Procedure (Connecting to POD Deck / Secondary POD Deck) > Installing Cassette Heater Unit
[1]
F-9-191
[3]
[2]
F-9-192
9 Installation > Cassete Heater-32 > Installation Procedure (Connecting to POD Deck / Secondary POD Deck) > Installing Cassette Heater Unit
4) Connect the cable [1] of the heater unit with the cable [2] on the POD deck.
x1
5) Fit the 2 ribs [2] of the heater mount into the 2 rear upper holes [1] inside the deck.
CAUTION:
Be sure to fit the ribs [2] of the heater mount into the rear upper holes [1] in the deck.
Otherwise, the foreign matter sensor that is attached to the heater mount can produce
improper signals.
[1]
9-91
[2]
[1]
F-9-193
[2]
F-9-194
9-91