Canon imagePRESS 1135 Series Service Manual page 1223

COPIER > OPTION > NETWORK
802XTOUT IEEE802.1X authenticatin timeout setting
Lv.1 Details Setting of timeout value for IEEE802.1X authentication
If the device executes 802.1X authentication, change the wait time
for response from the authentication server.
Use case In the case of slow/fast response from the authentication server
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Display/adj/set range 10 to 120
Unit Second
Default value 30
IKERETRY Setting of IKE retry times
Lv.1 Details Setting the number of retry in the case of no response from the
communication target at the time of IKE packet transmission.
Use case Upon request from the user
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Display/adj/set range 0 to 3
Default value 2
Supplement/memo IKE: Internet Key Exchange
SPDALDEL Initialization of SPD value
Lv.2 Details Initializing all the SPD value that is under management.
SPD value can be initialized without clearing SRAM.
Use case Initialize the value in the case of mismatch of SPD value when
adding IPSec board.
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 0
Supplement/memo SPD: database managed by SA (Security Association).
SPD value is managed when IPSec board is used. Normally, SRAM
needs to be cleared in the case of mismatch in SPD value.
NCONF-SW ON/OFF of Network Configurator function
Lv.1 Details ON/OFF setting for Network Configurator function.
If the user does not use the function, select OFF to prevent remote
attack through network.
Use case Upon request from the user
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Display/adj/set range 0 to 1
0: OFF, 1: ON
Default value 1
Supplement/memo Network Configurator function is a function to be used for
communication with NetSpot Device Installer, etc., and the network
setting can be changed from the remote.
8
Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > NETWORK
8 Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > NETWORK
COPIER > OPTION > NETWORK
IKEINTVL Setting of IKE retry interval
Lv.1 Details Setting of retry interval in the case of no response from the
communication target at the time of IKE packet transmission.
Use case Upon request from the user
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Display/adj/set range 1 to 30
Unit Second
Default value 5
Supplement/memo IKE: Internet Key Exchange
IPSDEBLV Setting of IPSec debug level
Lv.2 Details For R&D use
SP-LINK Mode setting at 1W sleep
Lv.1 Details Switch to execute 10base-T standby as default to make it possible
for the standby power 1W in sleep mode.
Use case To shift to sleep mode after negotiation (same as conventional
machines).
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF and then ON the main power supply.
Display/adj/set range 0 to 1
0: Shift to sleep mode with 10base-T
1: Shift to sleep mode after negotiation
Default value 0
8-280
T-8-71
8-280