Canon imagePRESS 1135 Series Service Manual page 1172

COPIER> FUNCTION> SYSTEM
HD-CLEAR Initializing specified partition
Lv.1 Details Initialize the HDD partition specified by CHK-TYPE.
Use case At the time of initialization of the HDD partition
Adj/set/operate method Select the item and press the OK key.
Caution Be sure to execute this item after CHK-TYPE.
Display/adjust/set range Upper 2 digits: Progress ratio (%, Returns to "00" at termination)
Lower 2 digits: Result at termination (00: Normally finished, Others:
Abnormally finished)
Related service mode COPIER> FUNCTION> SYSTEM> CHK-TYPE
DEBUG-1 Setting of log type and save timing
Lv.2 Details Set the types of logs to be stored and the timing to store logs in the
HDD.
Logs are used to analyze the cause of a trouble.
Use case At the time of analyzing the cause of a trouble
Adj/set/operate method Select the item and press the OK key.
Caution Change the setting value, following an instruction provided by Quality
Support Division.
Display/adjust/set range 0 to 3
0: Save PLOG at detection of Reboot/Exception
1: Safe PLOG at detection of Reboot/Exception/Encode
2: Save SUBLOG at detection of Reboot/Exception/Encode
3: Save SUBLOG in overwrite mode at detection of Reboot/
Exception/Encode
Default value 3
Related service mode COPIER> FUNCTION> SYSTEM> DEBUG-2(Leve2)
Supplement/memo PLOG can be printed by COPIER> FUNCTION> SYSTEM>
DEBUG-2.
SUBLOG cannot be printed. (It should be uploaded from SST.)
DEBUG-2 Output of log saved on HDD
Lv.2 Details Print the PLOG saved in HDD by COPIER> FUNCTION> SYSTEM>
DEBUG-1. (A4: Approx. 20 sheets)
SUBLOG is not printed. It should be uploaded from SST.
Use case At the time of printing PLOG
Adj/set/operate method Select the item and press the OK key.
Display/adjust/set range During operation: ACTIVE, At termination: OK!
Related service mode COPIER> FUNCTION> SYSTEM> DEBUG-1 (Level 2)
8
Service Mode > COPIER > FUNCTION (Operation / Inspection Mode) > SYSTEM
T-8-59
8 Service Mode > COPIER > FUNCTION (Operation / Inspection Mode) > SYSTEM
8-229
8-229