Canon imagePRESS 1135 Series Service Manual page 1126

■ PASCAL
COPIER> ADJUST> PASCAL
OFST-P-K Density adj at test print reading
Lv.1 Details To adjust the offset of the test print reading signal in PASCAL control
at auto gradation adjustment (full adjustment).
When the reader controller PCB is replaced or RAM is cleared, enter
the value of service label.
As the value is increased, the image after the adjustment gets
darker.
Use case When the reader controller PCB is replaced or RAM is cleared.
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power.
Caution When the setting value is changed, enter the changed value in the
service label.
Adjust the maximum density in P-OFFSET.
Display/adj/set range -128 to 128
Default value According to the adjustment value of the reader during factory
shipment
Related service mode COPIER> ADJUST> DENS> P-OFFSET
8
Service Mode > COPIER > ADJUST (Adjustment Mode) > PASCAL
T-8-40
8 Service Mode > COPIER > ADJUST (Adjustment Mode) > PASCAL
8-183
8-183