Canon imagePRESS 1135 Series Service Manual page 1371

SORTER> ADJUST
ALG-R-L Adj rear align plate shift(large) trimmr
Lv.1 Details To adjust the push-on amount of rear alignment plate when aligning
the inner sheets with 298 mm or more in depth.
As the value is increased by 1, push-on amount changes by 0.1 mm.
+: increase
-: decrease
Use case When the alignment is displaced in horizontal direction
Display/adj/set range -30 to 30
Unit 0.1 mm
Default value 0
GLUING Adj of gluing width: trimmer
Lv.1 Details [Not used]
To adjust the gluing width on the paper stack.
As the main grip is moved up and down, the space between the
paper stack and the scraper sheet changes.
As the value is changed by 1, the position of paper stack moves up
and down by 0.05 mm.
+: moves down
-: moves up
When the position of paper stack is lowered, the space is decreased
and gluing amount is decreased.
Use case When the gluing amount is not appropriate on the paper stack (spine
floating/peeling, over gluing occur etc.)
Display/adj/set range -60 to 60
Unit 0.05 mm
Default value 0
STK-DLV Adj of stack delivery motr shift: trimmr
Lv.2 Details To adjust the shift amount of stack delivery motor so that the position
where the cutter receives the paper is moved.
As the value is changed by 1, the feed amount of paper changes by
0.1 mm.
+: increase
-: decrease
Use case When changing the position where the cutter receives the paper
stack
Display/adj/set range -50 to 50
Unit 0.1 mm
Default value 0
8
Service Mode > SORTER > ADJUST
8 Service Mode > SORTER > ADJUST
SORTER> ADJUST
GRP-CHNG Adj of main grip shift position: trimmer
Lv.2 Details To adjust the grip position at the paper shift on the main grip so that
the nip position of paper stack is moved.
As the value is decreased by 1, the grip position is moved down by
0.1 mm (setting value 0 is equivalent to 10 mm.).
Use case When changing the nip position of paper stack by the stack delivery
roller for when the paper is shifted from the main grip to the stack
delivery roller
Caution This value cannot be set to the value that exceeds the initial status.
Display/adj/set range -50 to 0
Unit 0.1 mm
Default value 0
SIZE-H Adj of finish size in feed way: trimmer
Lv.2 Details To adjust the finish size length in feed direction.
As the value is changed by 1, the length is changed by 0.1 mm.
+: increase
-: decrease
Use case When the finish size is displaced in feed direction
Display/adj/set range -50 to 50
Unit 0.1 mm
Default value 0
SIZE-W Adj finish size in depth directn: trimmr
Lv.2 Details To adjust the finish size length in depth direction.
As the value is changed by 1, the length is changed by 0.1 mm.
+: increase
-: decrease
Use case When the finish size is displaced in depth direction
Display/adj/set range -50 to 50
Unit 0.1 mm
Default value 0
CV-LNG Adj of cut pstn from top edge: trimmer
Lv.2 Details To adjust the cut position on the finish size.
As the value is changed by 1, the cut amount is changed by 0.1 mm
from the top edge.
+: increase
-: decrease
Use case When the length from the front short side to the rear short side on
the cover sheet is displaced
Display/adj/set range -50 to 50
Unit 0.1 mm
Default value 0
8-428
8-428