Canon imagePRESS 1135 Series Service Manual page 1105

COPIER> ADJUST> ADJ-XY
ADJ-Y-DF Img pstn adj in DADF md: main scan[Frnt]
Lv.1 Details To adjust the image reading start position in main scanning direction.
When the reader controller PCB is replaced or RAM is cleared, enter
the value of service label.
As the value is increased by 1, the start position is shifted by 0.1 mm
toward rear.
Use case When the reader controller PCB is replaced or RAM is cleared.
Adj/set/operate method 1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, enter the changed value in the
service label.
Display/adj/set range 2 to 202
Unit 0.1 mm
Default value 102
Supplement/memo Because there is no side registration adjustment mechanism on the
original tray of the DADF.
STRD-POS Adj of read pstn in DADF front reading
Lv.1 Details To adjust the reading position in DADF front reading mode.
When the reader controller PCB is replaced or RAM is cleared, enter
the value of service label.
Use case When the reader controller PCB is replaced or RAM is cleared.
Adj/set/operate method 1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, enter the changed value in the
service label.
Display/adj/set range -100 to 100
Unit 0.1 mm
Default value 0
Related service mode COPIER> FUNCTION> INSTALL> STRD-POS
ADJ-X-MG Image ratio in book mode: sub scan[frnt]
Lv.1 Details To make a fine adjustment of image magnification in sub scanning
direction in copyboard reading mode.
When the reader controller PCB is replaced or RAM is cleared, enter
the value of service label.
As the value is changed by 1, image magnification is changed by 0.01
%.
+: Enlarge
-: Reduce
Use case When the reader controller PCB is replaced or RAM is cleared.
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key)
and press OK key.
2) Turn OFF/ON the main power.
Caution After the setting value is changed, enter the changed value in the
service label.
Display/adj/set range -50 to 50
Unit 0.01%
Default value 0
8
Service Mode > COPIER > ADJUST (Adjustment Mode) > ADJ-XY
8 Service Mode > COPIER > ADJUST (Adjustment Mode) > ADJ-XY
COPIER> ADJUST> ADJ-XY
ADJY-DF2 Image pstn in DADF mode: main scan[back]
Lv.1 Details To adjust the back side main scanning position at duplexing
simultaneous reading.
When the reader controller PCB is replaced or RAM is cleared, enter
the value of service label.
As the value is increased by 1, the image position is shifted by 0.1
mm toward rear.
Use case When the reader controller PCB is replaced or RAM is cleared.
Adj/set/operate method 1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, enter the changed value in the
service label.
Display/adj/set range 56 to 220
Unit 0.1 mm
Default value 124
8-162
T-8-32
8-162