Save Filetype - Siemens SCALANCE W770 Series Configuration Manuals

Configuration
4.2 Load and Save
Result
The current configuration of the TFTP server for Load&Save is displayed.
4.2.2

save filetype

Description
With this command, you save files on a TFTP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
save filetype <filetype> tftp {ipv4 <ucast_addr> | fqdn-name <FQDN>
| ipv6 <ip6_addr>} [port <tcpport (1-65535)>] file <filename>
The parameters have the following meaning:
Parameter
filetype
filetype
tftp
ipv4
ucast_addr
fqdn-name
FQDN
ipv6
ip6_addr
port
tcpport
file
filename
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
For information on the file types , refer to this list (Page 82).
86
Description
Keyword for a file type to be loaded
Name of the file type
Keyword for a TFTP server
Keyword for an IPv4 address
IPv4 unicast address of the TFTP server Enter a valid unicast IPv4 address.
Keyword for a domain name
Domain name (Fully Qualified Domain
Name) of the TFTP server
Keyword for an IPv6 address
IPv6 address of the TFTP server
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
Keyword for a file name to be assigned -
Name of the file
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
Maximum of 100 characters
-
-
Maximum of 100 characters
-
Enter a valid unicast IPv6 address.
-
1 ... 65535
Maximum of 100 characters
Configuration Manual, 09/2017, C79000-G8976-C324-08