Show Ip Dhcp-Server Bindings; Commands In The Global Configuration Mode - Siemens SCALANCE W770 Series Configuration Manuals

Result
The configuration of the DHCP server and the DHCP options is displayed.
8.5.1.2

show ip dhcp-server bindings

Description
This command shows the current assignments of IPv4 addresses of the DHCP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ip dhcp-server bindings
Result
The information is displayed.
8.5.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network protocols
8.5 DHCP server
389