Table of Contents
Advertisement
Network structures
7.1 WLAN
7.1.5.40
no wlan dfs multi-radar-detection
Description
With this command you disable access points exchanging information about radar signals
among themselves and verifying them.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan dfs multi-radar-detection
Result
The function is disabled.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
You enable the function with the wlan dfs multi-radar-detection command.
7.1.5.41
wlan dhcp renew (Client)
Description
Note
This command is only available in the client mode.
With this command you specify that after changing to a different access point, the IPv4 address
of the client is checked. If he IPv4 address is invalid, a new IPv4 address is requested from
the DHCP server.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
244
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
