Signal Recorder; The "Show" Commands; Show Wlan Signal-Recorder (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Functions specific to SCALANCE

5.3 Signal recorder

Syntax
Call the command without parameters:
no web-session-timeout
Result
Automatic logoff is disabled.
Further notes
You enable automatic logoff with the web-session-timeout command.
You display the current timeout setting with the show web-session-timeout command.
5.3 Signal recorder
This section describes the commands relevant for working with the signal recorder.
5.3.1

The "show" commands

This section describes commands with which you display various settings.
5.3.1.1

show wlan signal-recorder (Client)

Description
This command shows the status of the signal recorder. You can call the command before,
after or during the recording.
Note
This command is only available in the client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
116
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08