Ipcf-Ht; The "Show" Commands; Show Wlan Ipcf-Ht - Siemens SCALANCE W770 Series Configuration Manuals

5.5

iPCF-HT

This section describes the commands relevant for working with iPCF-HT (industrial Point
Coordination Function High Throughput).
Note
This commands are only available with the following KEY-PLUGs:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Note
Use of iPCF-HT
The function iPCF-HT
● and other iFeatures (e.g. iPCF, iPCF-MC, iPRP) are not compatible with each other and
cannot be used at the same time on a device.
● can only be used in the frequency band 5 GHz and with WLAN mode "(only) IEEE 802.11n".
● is available only on the WLAN interface 1.
It is advisable only to use an MCS index.
5.5.1

The "show" commands

This section describes commands with which general system properties can be displayed and
configured.
5.5.1.1

show wlan ipcf-ht

Note
This command is only available with the following KEY-PLUG:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
Description
This command shows the settings of iPCF-HT.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.5 iPCF-HT
131