Completion Of Command Entries - Siemens SCALANCE W770 Series Configuration Manuals

Result
The mode-specific as well as the global commands are displayed.
Note
Incomplete command names
If you have specified an incomplete command when calling the help function, a list of all
commands that start with the term you have entered is created.
Note
Output in pages
With long lists, the results are displayed as pages. If -- more -- appears at the lower edge
of the display, you can move to the next page with the spacebar. If the display is in pages, you
cannot page back. You exit the page display with the q key.
2.7.5.3

Completion of command entries

Description
The command interpreter of the Command Line Interface supports you when you enter
commands.
As soon as the first characters of the command have been entered in the input line, the system
can complete the entry as long as the character string is unambiguous.
This can be repeated after entering further characters.
Procedure
Enter the first characters of the command.
Press the tab key.
Result
The command interpreter completes the input as long as the command is unambiguous.
If you enter a character string that cannot be completed to form a command, an error message
is displayed.
● The command is not unique: % Ambiguous Command
● The command is unknown: % Invalid Command
● The command is incomplete: % Incomplete command
If the entry is not yet complete, enter further characters.
With ?, you obtain a list of the possible commands.
Repeat this if necessary until the command is complete and can execute.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
2.7 General CLI commands
41