Ipv6 Transparent Mode (Client); No Ipv6 Transparent Mode (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Layer 3 functions
10.1 NAT
10.1.3.1

ipv6 transparent mode (Client)

Note
This command is only available in the client mode.
Description
With this command, you enable the transparent mode. IPv6 frames are forwarded unchanged
between Ethernet and WLAN.
Requirement
● You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
● "Own" is not set for "MAC Mode".
● IPv6 is deactivated.
Syntax
Call the command without parameter assignment:
ipv6 transparent mode
Result
The transparent mode is activated.
Further notes
You disable the transparent mode with the command no ipv6 transparent mode.
10.1.3.2

no ipv6 transparent mode (Client)

Note
This command is only available in the client mode.
Description
With this command, you disable the transparent mode.
458
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08