Clear Counters - Siemens SCALANCE W770 Series Configuration Manuals

● Version
● Date
4.1.2

clear counters

Description
With this command, you reset the counters of an interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
clear counters [<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
If no parameters are specified, the counters for all interfaces are reset.
Result
The counters of the interface are reset.
Further notes
You can display the statistical information of the interfaces with the show interfaces ...
counters command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Type or speed of the interface
Module no. and port no. of the interface
Configuration
4.1 System
Range of values / note
Specify a valid interface.
59