No Event Config - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

12.1 Diagnostics

The setting deciding which message of the device is stored or forwarded is configured.

Further notes

You display the status of the events and the clients with the show events config command.

You delete the settings with the no event config command.

With this command, the clients are not enabled.

To enable the clients, use the client config command.

Changing several message types or clients

With each command call, you can only select one message type and one client.

If you want to process several message types or clients, it may be more efficient to first select

the all option and then disable individual elements.

no event config

With this command, you configure which of the various message types of the device will no

longer be stored or forwarded.

You are in the EVENTS Configuration mode.

The command prompt is as follows:

cli(config-events)#

Call up the command with the following parameters:

no event config {cold-warmstart | linkchange | authentication-

failure | power-change | faultstate-change | stp-change | overlap-ap

Client that sends the e-mails

Client that sends the SNMP traps

The device triggers an error. The error LED lights up.

All clients at once

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents