Wlan Rts-Cts Threshold; Commands In The Vap Interface Configuration Mode - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

wlan rts-cts threshold

With this command, you specify the packet size starting at which RTS/CTS (Request To Send/

Clear To Send) will be used.

You are in the Interface Configuration mode of the WLAN interface.

The command prompt is as follows:

cli (config-if-wlan-0-X)#

Call up the command with the following parameters:

wlan rts-cts threshold < bytes(1-2346)>

The parameter has the following meaning:

The packet size is specified.

Further notes

You display the setting with the show wlan advanced <wlan 0/X> command.

This section describes commands that you can call up in the VAP Interface Configuration

mode. Depending on the Interface selected, various command sets are available.

In the Global Configuration mode, enter the interface vapX 0/Y command to change to

● If you exit the VAP Interface Configuration mode with the exit command, you return to

the Global Configuration mode.

● If you exit the VAP Interface Configuration mode with the end command, you return to the

Privileged EXEC mode.

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Size specified in bytes

Range of values / note

Default: 2346

Network structures

Show Quick Links

Table of Contents