No Spanning-Tree Mst Hello-Time; Commands In The Mstp Configuration Mode - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.3 Spanning Tree
7.3.4.11

no spanning-tree mst hello-time

Description
With this command, you reset the hello time after which the bridge sends its configuration
BPDUs to the default value.
The default value is 2 seconds.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree mst hello-time
Result
The setting for the hello time is reset to the default value.
Further notes
You can configure the setting for the hello time with the spanning-tree mst hello-
time command.
You display this setting and other information with the commands that start with show
spanning tree ....
7.3.5

Commands in the MSTP configuration mode

This section describes commands that you can call up in the MSTP configuration mode.
In the Global configuration mode, enter the spanning-tree mst configuration
command to change to this mode.
● If you exit the MSTP configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the MSTP configuration mode with the end command, you return to the Privileged
EXEC mode.
334
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08