Wlan Spectrumanalyzer Stop (Access Point); Remote Capture - Siemens SCALANCE W770 Series Configuration Manuals

Further notes
You stop the recording with the wlan spectrumanalyzer stop command.
You display the settings of the spectrum analyzer with the show wlan
spectrumanalyzer command.
5.9.2.3

wlan spectrumanalyzer stop (Access Point)

Description
With this command, you stop the recording with the spectrum analyzer .
Note
This command is available only in access point mode.
Requirement
● The WLAN interface is enabled.
● A recording was started.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan spectrumanalyzer stop
Result
The measurement was ended.
Further notes
You start the recording with the wlan spectrumanalyzer start command.
5.10

Remote capture

This section describes the commands relevant for working with remote capture.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.10 Remote capture
159