Show Interface Access Lists; Commands In The Global Configuration Mode - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Security and authentication

11.4 MAC access control list

The configuration of the access control lists is displayed.

show interface access lists

This command shows the access control list of one or all interfaces.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

cli> or cli#

Call up the command with the following parameters:

show interface access-lists [{<interface-type><interface-id>|vlan

<vlan-id(1-4094)>}]

The parameters have the following meaning:

interface-type

interface-id

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

If you do not select any parameter from the parameter list, the configuration is displayed for

all available interfaces.

The access control list of the selected IP interface is displayed.

This section describes commands that you can call up in the Global configuration mode.

In Privileged EXEC mode, enter the configure terminal command to change to this mode.

Type or speed of the interface

Module no. and port no. of the interface

Keyword for a VLAN connection

Number of the VLAN

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Range of values / note

Enter a valid interface.

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents