Management Access Control List; The "Show" Commands; Show Authorized-Managers - Siemens SCALANCE W770 Series Configuration Manuals

11.6

Management Access Control List

This section describes the commands relevant for working with the management access
control list.
11.6.1

The "show" commands

This section describes commands with which you display various settings.
11.6.1.1

show authorized-managers

Description
This command shows the information about the configuration of the authorized managers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show authorized-managers[{ip-source<ip-address>|ipv6-
source<prefix>}]
The parameters have the following meaning:
Parameter
ip-source
ip-address
ipv6-source
prefix
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The information about the configuration of the authorized managers is displayed.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Keyword for the IPv4 network or host
address
Value for an IPv4 address
Keyword for the IPv6 network or host
address
Value for an IPv6 address
Security and authentication
11.6 Management Access Control List
Range of values / note
-
Enter a valid IPv4 address.
-
Enter a valid IPv6 address.
577