Dcp Server; No Dcp Server - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Network protocols

8.1 IPv4 protocol

dcp server

With this command, you configure the read and write permissions for the DCP server and

You are in the Global Configuration mode.

The command prompt is as follows:

cli(config)#

Call up the command with the following parameters:

dcp server {read-only|read-write}

The parameters have the following meaning:

The read and write permissions for the DPC server are configured.

The DCP server is enabled.

Further notes

You disable the DCP server with the no dcp server command.

With this command, you disable the DCP server.

You are in the Global configuration mode.

only reading is permitted on the DCP

reading and writing is permitted on the

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Range of values / note

Default: read-write

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents