Option Value-String - Siemens SCALANCE W770 Series Configuration Manuals

Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
option <option-code> value-hex <dhcp-param>
The parameters have the following meaning:
Parameter
option-code
dhcp-param
Result
The DHCP option is configured. In total a maximum of 20 DHCP options are possible.
Further notes
You display the setting with the show ip dhcp-server-pools command.
You disable the IPv4 address band with the no pool-enable command.
You delete the DHCP option with the no option command.
8.5.3.5

option value-string

Description
With this command you configure DHCP options 12, 66 and 67 that contain a string as DHCP
parameter. The DHCP options 66 and 67 are created automatically when the IPv4 address
band is created.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Code of the DHCP option
DHCP parameter in hexadecimal
Range of values / note
Enter a valid DHCP option.
The following DHCP options are not suppor‐
ted:
● 50 - 60
● 255
Enter a valid hexadecimal value.
Format: XXXXX e.g. C0A86402
Network protocols
8.5 DHCP server
399