Commands In The Interface Configuration Mode Vlan - Siemens SCALANCE W770 Series Configuration Manuals

Syntax
Call up the command with the following parameters:
no ip access-group [<access-list-number(1-20)>]{in|out}
The parameters have the following meaning:
Parameter
access-list-
number
in
out
If you do not specify a number for an access control list, all lists of an interface are disabled.
Result
The packet filtering according to the access control list (ACL) is canceled.
Further notes
You enable the setting with the ip access-group command.
You display the configuration of the access control list with the show access-lists
command.
11.5.4

Commands in the Interface configuration mode VLAN

This section describes commands that you can call up for VLAN in the Interface configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface vlan $$$ command to change to
this mode. When doing this, you need to replace the $$$ placeholders with the relevant VLAN
ID
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Number of the access control list
Specifies that incoming packets are fil‐
tered
Specifies that outgoing packets are fil‐
tered
Security and authentication
11.5 IP access control list
Range of values / note
1 ... 20
-
-
559