Wlan Guard Interval (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Result
The frequency band for the WLAN interface is specified.
Further notes
You display the setting with the show wlan basic <wlan 0/X> command.
7.1.5.51

wlan guard interval (access point)

Description
With this command, you specify the send pause that must be kept to between two transferred
OFDM symbols.
Note
This command is available only in access point mode.
Requirement
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan guard interval { GI400 | GI800 }
The parameters have the following meaning:
Parameters
GI400
GI800
Result
The function is enabled and the send pause set.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
The send pause is 400 ns (default)
The send pause is 800 ns
Network structures
7.1 WLAN
253