No Ip Dhcp-Server Pool - Siemens SCALANCE W770 Series Configuration Manuals

Parameter
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL Configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the exit command.
You delete the entry with the no ip dhcp-server pool command.
8.5.2.5

no ip dhcp-server pool

Description
With this command, you delete the required IPv4 address band.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip dhcp-server pool <pool-id (1-1)>
The parameter has the following meaning:
Parameter
pool-id
Result
The required IPv4 address band is deleted.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Type of interface
Module no. and port no. of the interface
Description
ID of the addressed IPv4 address band
Network protocols
8.5 DHCP server
Range of values / note
Specify a valid interface.
Range of values / note
1
393