No Nat Ipv4 Multicast Forward Local-To-Global (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Further notes
You disable the forwarding with the no nat ipv4 multicast forward local-to-
global command.
10.1.3.11

no nat ipv4 multicast forward local-to-global (Client)

Note
This command is only available in the client mode.
no nat ipv4 multicast forward local-to-global
Description
With this command, you disable the forwarding of multicast frames. The multicast frames
incoming on the local interface are not forwarded.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call the command without parameters:
no nat ipv4 multicast forward local-to-global
Result
The forwarding of multicast frames is disabled.
Further notes
You enable the forwarding with the nat ipv4 multicast forward local-to-global
command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Layer 3 functions
10.1 NAT
467