Wlan Signal-Recorder Stop (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

wlan signal-recorder stop (client)

With this command, you stop the recording with the signal recorder.

This command is only available in the client mode.

● A recording was started.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

cli> or cli#

● The WLAN interface is enabled.

Call up the command with the following parameters:

wlan signal-recorder <wlan 0/X> stop

The parameter has the following meaning:

For information on identifiers of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 29)".

The recording was stopped.

Further notes

You start the recording with the wlan signal-recorder start command.

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

WLAN interface

Functions specific to SCALANCE

5.3 Signal recorder

Range of values / note

Enter a valid interface.

Show Quick Links

Table of Contents