No Ipv6 Address Dhcp - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.2 IPv6 protocol
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 address dhcp [rapid-commit]
The parameters have the following meaning:
Parameter
rapid-commit
Result
The setting is configured.
Further notes
You disable the setting with the no ipv6 address dhcp command.
You show the setting with the show ipv6 dhcp interface command.
You can display the statistics of the DHCPv6 client with the show ipv6 dhcp client
statistics command.
8.2.4.6

no ipv6 address dhcp

Description
With this command, you delete the IPv6 address and disable DHCPv6.
374
Description
Reduces the procedure of 4 DHCPv6 mes‐
sages (SOLICIT, ADVERTISE , REQUEST,
REPLY) to 2 DHCPv6 messages (SOLICIT,
REPLY).
This is only possible when the DHCPv6 serv‐
er supports this.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
Configuration Manual, 09/2017, C79000-G8976-C324-08