No Port (Access Point); Vlan - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Network structures

no port (Access Point)

With this command, you disable the monitoring of the VAP interface.

This command is available only in access point mode.

You are in the force roaming configuration mode.

The command prompt is as follows:

cli (config-wlan-froid-$)#

Call up the command with the following parameters:

no port <vapX 0/Y>

The parameter has the following meaning:

For information on identifiers of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 29)".

The function is disabled.

Further notes

You display this setting and other information with the show wlan force roaming ip-

down command.

You enable this setting with the port command.

This section describes commands for configuring and managing virtual networks (VLANs).

VAP interface

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Range of values / note

Specify a valid interface.

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents