Spanning-Tree; No Spanning-Tree - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.3 Spanning Tree
7.3.3.1

spanning-tree

Description
The Spanning Tree Protocol is used to monitor a LAN for redundant connections. These are
blocked and reactivated when necessary if there are changes to the network topology.
With this command, you enable the spanning tree function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree
Result
The spanning tree function is enabled.
Further notes
As default the function is "enabled".
You disable the spanning tree function with the no spanning tree command.
You can display the status of this function and other information with the show spanning
tree detail command.
You can display information about active ports with the show spanning tree active
command.
7.3.3.2

no spanning-tree

Description
With this command, you disable the spanning tree function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
310
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08