Commands In The Wlan Configuration Mode; Wlan Security Ap-Radius-Authenticator - Siemens SCALANCE W770 Series Configuration Manuals

11.3.2

Commands in the WLAN configuration mode

This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the wlan command to change to this mode.
Commands relating to other topics that can be called in the WLAN configuration mode can be
found in the relevant sections.
● If you exit the WLAN configuration mode with the exitcommand, you return to the Global
configuration mode.
● If you exit the WLAN Configuration mode with the end command, you return to the
Privileged EXEC mode.
11.3.2.1

wlan security ap-radius-authenticator

Description
With this command, you enable the RADIUS server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator <index (1-2)>
The parameter has the following meaning:
Parameters
index
Result
The RADIUS server is enabled.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Index of the RADIUS server
Security and authentication
11.3 WLAN
Range of values / note
1...2
499