Mac Access Control List; The "Show" Commands; Show Access-Lists - Siemens SCALANCE W770 Series Configuration Manuals

Result
Non-IP packets can also be exchanged between the client and the SCALANCE W700 devices
configured on the access point as permitted communications partners.
11.4

MAC access control list

This section describes commands for working with MAC access control lists.
11.4.1

The "show" commands

This section describes commands with which you display various settings.
11.4.1.1

show access-lists

Description
This command shows the configuration of the access control lists (Access Control List).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show access-lists [ [{ip | mac}] <access-list-number (1 - 20)> ]
The parameters have the following meaning:
Parameter
ip
mac
access-list-
number
If you do not select any parameters from the parameter list, the configuration of all access
control lists will be displayed.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Selects IP-based access lists (IP ACL)
Selects MAC-based access lists (MAC
ACL)
Number of the access control list
Security and authentication
11.4 MAC access control list
Range of values / note
-
-
1 ... 20
545