Vap Security Default-Key (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Security and authentication
11.3 WLAN
Further notes
You display the settings with the show wlan security <vapX 0/Y> command.
11.3.5.3

vap security default-key (access point)

Description
With this command, you specify which WEP key from the key table is used for encryption.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call up the command with the following parameters:
vap security default-key <index (1-4)>
The parameter has the following meaning:
Parameters
index
Result
The WEP key is specified.
Further notes
You display the settings with the show wlan security <vapX 0/Y> command.
528
Description
Index of the key table
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
1...4
Configuration Manual, 09/2017, C79000-G8976-C324-08