Commands In The Global Configuration Mode; Wlan - Siemens SCALANCE W770 Series Configuration Manuals

Network structures

7.1 WLAN

Result
The WLAN statistics are reset.
Further notes
You display the WLAN statistics tables with the show wlan statistics command.
7.1.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
7.1.3.1 wlan
Description
With this command, you change to the WLAN Configuration mode.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
wlan
Result
You are in the WLAN Configuration mode.
The command prompt is as follows:
cli (config-wlan)#
204
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08